a pair of m-Audio 61es boards

You need one or moreMIDI keyboards to really play the Miditzer
Post Reply
User avatar
silentfilmmusic
Posts: 362
Joined: Tue Nov 08, 2005 12:35 pm
How many Style 216 did Wurlitzer make?: 0
Contact:

a pair of m-Audio 61es boards

Post by silentfilmmusic » Tue Nov 29, 2011 10:23 pm

Am trying to work with a set-up using two M-audio 61es keyboards (Mtz 216). In Miditzer Settings, they both show up with identical names. Any suggestions for telling which one is which? I don't want to have to figure it out by trial and error every time I set up. Is there an order they get loaded based on midi channel number or position in the USB hub?

Am tryng to graduate to this for my home/portable rig instead of toting a single 76-key keyboard that's split in the middle.

Thanks.

Ben

reuel
Senior Member
Posts: 230
Joined: Tue Nov 03, 2009 5:44 am
Spam Stopper: theatre organ
How many Style 216 did Wurlitzer make?: 12
Location: Australia

Re: a pair of m-Audio 61es boards

Post by reuel » Wed Jul 29, 2020 4:37 pm

I have 2 M-audio Oxygen 61 Silver.
One keyboard has to be connected thru MIDI-OUT port (will need AC adopter too) using Roland UM-One.
Could not connect both m-audio keyboards via USB as they will have the same name. If you always load them in sequence, you can use them but must be set up everytime.

Buy boards with MIDI-OUT port always or buy 2nd keyboard from another brand.

ChuckH
Groupie
Posts: 82
Joined: Thu Jun 25, 2009 9:24 pm
How many Style 216 did Wurlitzer make?: 0
Location: Perth, Western Australia

Re: a pair of m-Audio 61es boards

Post by ChuckH » Thu Jul 30, 2020 3:11 am

Hi Ben,

I had the same issue earlier this year with Acorn midi controller keyboards. After exhausting other possibilities, I ended up removing the top casing, removing the top two PCBs and removing the keys and key contact PCBs to get to the solder points on the other side. I then removed the diodes and soldered new wires to the key contacts. The other end of these wires were connected to a 16-wire ribbon cable with a suitable connector at the other end to match the Midi-Boutrique midi encoder. From there, a Midi-USB cable connected the encoder to the USB port on the PC mother board I had installed in back of the Conn's console.

Hope the attached is of some use to you.

Charles (Western Australia)
You do not have the required permissions to view the files attached to this post.
Charles Hughes, Melbourne, Australia

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests